Repair information 4-179
7510
10. Remove the tray 4 front cables (C) from the bottom plates (F).
Replacement note: Before re-installing:
— It is recommended that all four cables be replaced.
— Ensure tray 4 front cables (C) are not twisted or kinked.
— Route the cables properly as shown in the figure.
— Replace the cables by setting the frame assembly (B) on its side as shown in the figure.
2000-sheet dual input (TTM)—media feed unit assembly removal (tray 4)
1. Remove the media tray 2 assembly.
2. Remove the tray module left cover. See “2000-sheet dual input (TTM)– tray module left cover removal” on
page 4-167.
3. Remove the TTM media tray 3 assembly. See “2000-sheet dual input (TTM)–TTM media tray 3 assembly
removal” on page 4-171.
4. Remove the TTM media tray 4 assembly. See “2000-sheet dual input (TTM)–TTM media tray 4 assembly
removal” on page 4-170.
5. Remove the tray 4 media transport assembly. See “2000-sheet dual input (TTM)–TTM tray 4 media
transport assembly removal” on page 4-175.
6. Disconnect the two connectors from the media feed unit assembly (A).
To Next Page
Loading...
