Diagnostic aids 3-17
7510
Quick Disk Test Testing... appears on the LCD. This test cannot be canceled. After the test finishes,
either Quick Disk Test Passed or Quick Disk Test Failed appears on the LCD. This message
remains until you touch Back.
Disk Test/Clean
This test performs a low-level format of the hard disk.
Warning: This test destroys all data on the disk and should never be performed on a good disk. Use this test
only when the disk contains bad data and is unusable. When this test completes, the disk automatically
initializes with a new file system; therefore it is unnecessary to format the disk.
To run the Disk Test/Clean Test:
1. Touch DEVICE TESTS from the Diagnostics Menu.
2. Touch Disk Test/Clean Test.
Contents will be lost. Continue? appears on the LCD. To exit this test and return to DEVICE TESTS,
touch No. This is your only chance to exit this test; once the test has begun, it cannot be stopped.
While this test runs, the following graphic appears:
This test cannot be interrupted once it has begun. After the test finishes, either Disk Test/Clean Test
Passed or Disk Test/Clean Test Failed appears on the LCD. Press Stop to clear the final message
and return to DEVICE TESTS.
Formatting Disk
1/1 0%
DO NOT
POWER OFF
To Next Page
Loading...
