2-184 Service Manual
7510
2
Check the sensor (media out) for operation.
1. Enter the Diagnostics Menu.
2. Touch INPUT TRAY TESTS.
3. Touch Sensor test.
4. Touch Tray 1.
5. Touch Media out.
1. Enter the Diagnostics Menu.
2. Touch INPUT TRAY TESTS.
3. Touch Sensor test.
4. Touch Tray 2.
5. Touch Media out.
1. Enter the Diagnostics Menu.
2. Touch INPUT TRAY TESTS.
3. Touch Sensor test.
4. Touch Tray 3.
5. Touch Media out.
1. Enter the Diagnostics Menu.
2. Touch INPUT TRAY TESTS.
3. Touch Sensor test.
4. Touch Tray 4.
5. Touch Media out.
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked?
Go to step 4. Go to step 3.
3
Check the sensor (media out) connection for proper
connection on the appropriate media tray.
Is the above component connected properly?
Replace the
appropriate sensor
(media out).
Go to “1X 500-
sheet drawer
(1TM)–sensor
(media out)
removal” on
page 4-243, “3X
500-sheet drawer
(3TM)–sensor
(media out)
removal” on
page 4-221, or
“2000-sheet dual
input
(TTM)–sensor
(media out)
removal” on
page 4-192.
Replace the
connection.
4
Perform a POR.
Does the error continue when the power is turned off/on?
Replace the upper
printer engine card
assembly.
Go to “Upper
printer engine
card assembly
removal” on
page 4-77.
Problem solved.
Step Check Yes No
To Next Page
Loading...
