Repair information 4-265
7510
2
Analyze the In/out setup.
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Control setup cycles
5. Touch Cycle result values
Locate the following new values for the following settings:
Y- Skew adjustment
M- Skew adjustment
C- Skew adjustment
K- Skew adjustment
Is the value for all of the above settings a “0”?
Go to step 3. Go to step 5.
3
Perform the skew rough setup.
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Control setup cycles
5. Touch Skew rough setup
Does the above test pass?
Go to step 4. Go to step 7.
Step Check Yes No
To Next Page
Loading...
