Installation/Owner's Manual
6-18
When you press the auto changer over operation tab from the auto control menu, the following screen
to set the auto change over operation will be displayed.
The group that has been set up for the auto changer over operation and the
details of the setting are displayed in table format.
You can create/edit/delete the group to apply
the auto change over operation.
Possible to set up the condition
about automatic conversion drive
Item Description
Name of Auto change over operation group is displayed.
Set temperature(St) of Auto change over operation group is displayed.
Temperature difference(dT) to maintain the temperature through heat and cool
based on the temperature difference is displayed.
Method to measure the temperature difference is displayed.
- Fixed: Method of operating the Auto change over operation function based
on the temperature detected by applicable indoor unit by designating the
representative indoor unit to operate based on the set temperature within the
group.
- Operating: Method of operating the Auto change over operation function
based on the temperature detected by applicable indoor unit by designating
the representative indoor unit to operate based on the set temperature within
the group.
- Average: Method of operating the Auto change over operation function with
the average temperature detected from the indoor units within the group.
Whether Auto change over operation function is applied is displayed.
Number of units included in each group is displayed.
Group name
Set temperature
Temperature
reference
Temperature
difference
En/Disable
Unit count
Refer to the following table for descriptions on the setting of auto change over operation.
6. Auto control menu
To Next Page
Loading...
Need help?
General
