Installation/Owner's Manual
11-3
Remote service setting
Keep the following steps to set the remote service for accessing the SVCNet.
1. When you press the ʻNetworkʼ tab from the ʻAdvanced Environment Setting, the screen to set the
remote service will be displayed. Enter the remote service setting information and press the [Apply]
button. For detail description of each input item, refer to the following table.
After setting the remote service,
press the [Apply] button
Classification Item Description (CHECK SMART)
Select whether to use the function for sending the
information of the AC Smart to the SVCNet..
Enter the server address of the SVCNet.
Enter the server port of the SVCNet.
Specify the period to update the information at the
SVCNet by minute.
Enter the IP address set at the current AC Smart.
Enter the information about the location where the
current AC Smart is installed.
The code given for managing the field
Remote service
setting
Enable, Disable
Service server address
Service server port
Site address
Site name
Site code
Update Frequency(Min)
Remote service
Information
Site Information
11. Introduction to Advanced Environment setting
To Next Page
Loading...
Need help?
General
