LG V-NET AC Smart II Advanced Control Smart User Manual

2. AC Smart II Installation
AC Smart
2-3
Setting unit address
First, you must assign the address to each unit so that the address of each unit (Indoor unit, ventilator,
Eco V DX , On/Off, AWHP) is not duplicated by considering the overall installation composition
connected to AC Smart II.
The address of the unit can be set in hexadecimal from 00 to FF.
The following is an example of assigning the address to the unit.
Caution: Setting address for indoor unit, ventilator, On/Off unit and
AWHP unit
You cannot set the same address for the indoor unit, ventilator, Eco V DX, On/Off unit
and AWHP. Make sure not to have duplicate addresses.
00
Group
number
Unit
number
00
Group
number
Unit
number
Reference: Setting address for device
When setting the address of a unit (Indoor unit, ventilator, On/Off
unit, AWHP unit), it is recommended to set the first digit as the
group number, and second as unit number for easy identification.
AC SMART II
PI485
PI485
PI485
Ventilator
On/Off unit
AWHP Outdoor unit
AWHP Indoor unit
Air conditioner
outdoor unit
Indoor unit 1 Indoor unit 2 Indoor unit 3

LG V-NET AC Smart II Advanced Control Smart Specifications

General

Brand	LG
Model	V-NET AC Smart II Advanced Control Smart
Category	Air Conditioner
Language	English