Installation/Owner's Manual
8-6
Setting the operating time search condition
You can set the search condition for the accumulative operating time and monthly operating time. To
set the search condition, proceed as follows. Accumulative operating time is used as an example. You
can also set the search condition for the monthly operating time in the same way.
1. Press the [Condition setting] button located at the ʻAccumulative operating timeʼ tab. ʻCondition
settingʼ screen to set the search unit and target is displayed.
When you press the [Condition setting] button, the
"Condition setting" screen will be displayed.
3. Set the search unit and target, and press the [Apply] button. Refer to the following table for detailed
description of the setting item.
Press [Schedule pattern wizard] button
8. Statistical menu
To Next Page
Loading...
