ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 8-1
Beta Draft Confidential
8
Configuring ATM Over MPLS Trunks
ATM over Multi-Protocol Label Switching (ATMoMPLS) trunks support a
multiservice MPLS core solution by enabling connection of Lucent ATM switches to
MPLS core networks via Juniper T-series (T640 & T320) routers running JUNOS
Release 6.2 or above.
This section contains:
• “ATMoMPLS Trunk Licensing” on page 8-2
• “About ATMoMPLS Trunks” on page 8-6
• “Configuration Overview” on page 8-12
• “Configuring Physical Ports for ATMoMPLS Trunks” on page 8-14
• “Configuring Feeder Logical Ports” on page 8-16
• “Configuring ATMoMPLS Trunk Logical Ports” on page 8-34
• “Configuring the ATMoMPLS Trunk” on page 8-43
Note – Use of the ATMoMPLS Trunking feature requires an additional license, which
you must purchase from Lucent Technologies. The license is supplied as a 50-byte
alphanumeric key that you enter at the Navis EMS-CBGX command line to unlock
ATMoMPLS management features for use on the number of switches permitted by
your license. For more information, refer to “ATMoMPLS Trunk Licensing” on
page 8-2.
Note – To learn more about configuring the MPLS core routers, refer to the JUNOS
Internet software documentation. To obtain the most current versions of Juniper
Networks technical documents, refer to the product documentation page on the
Juniper Networks Web site, which is located at
http://www.juniper.net.
To Next Page
Loading...
