Beta Draft Confidential
Configuring ATM PVCs
Manually Defining the Circuit Path
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 1/19/0510-69
3. In the Path tab, click on the Select button to display the Define Path dialog box, as
shown in Figure 10-16.
Figure 10-16. Define Path Dialog Box
The Defined Path From Switch field displays a listing of hops (trunk-switch pairs)
in the defined path.
4. Define the path using the Trunks and Next Switch fields, selecting trunk-switch
pairs from the list of available hops to include the hop in the circuit path, and
choose Add To Path. When there are multiple trunks between two switches, select
[Any Trunk] and the next switch to route the circuit based on OSPF.
5. Click the Non-Lucent Node button to display the PNNI Node ATM Address
dialog box (Figure 10-17).
Figure 10-17. PNNI Node ATM Address Dialog Box
To Next Page
Loading...
