Lucent Technologies CBX 500 - Configuring an ATM or FR Circuit over a Layer 2 Tunnel

Beta Draft Confidential
9-601/19/05 ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000
Configuring ATM Over MPLS Gateway Solution on CBX 3500
Configuring a Layer 2 Tunnel Over MPLS Core Network
Configuring an ATM or FR Circuit over a Layer 2 Tunnel
After the Layer 2 tunnel is configured, you can configure a circuit over the MPLS
core. See the following chapters for circuit configuration information:
• Chapter 10, “Configuring ATM PVCs”
• Chapter 17, “Configuring SVC Parameters”
• Chapter 9, “Configuring ATM Over MPLS Gateway Solution on CBX 3500”