Lucent Technologies MAX TNT - Page 118

Index-2 MAX TNT Hardware Installation Guide
Index
F
environmental specifications, C-4
Ethernet
connecting unit to
, 3-12
equipment required to install
, B-2
interface specifications
, B-2
Ethernet-3 card
specifications
, A-15
status lights
, A-15
exhaust shield, installing
, 3-6
F
features, overview, 1-1
flash card, verifying integrity of
, 3-14
G
grounding, E1, A-9
H
hardware, overview, 1-2
HDLC
nailed channels and
, A-17
heat
dissipation of
, 3-1
high output power supplies
connecting ac
, 3-10
connecting dc
, 3-10
identifying ac
, 3-7
identifying dc
, 3-7
installing
, 3-7
not hot swappable with existing power supplies
, 3-7
Hybrid Access
cards requiring it
, A-17
how the unit uses it
, A-17
I
IDSL card
cabling specifications
, B-20
installation
connecting to the LAN
, 3-12
installing the MAX TNT chassis
, 3-1
maximum distance between MAX TNT and WAN
interface equipment
, A-9
overview
, 3-1
power supplies
, 3-8
preparing for
, 2-3
required tools
, 2-3
requirements for
, 2-1
slot cards
, 3-15
software requirements for slot cards
, 3-15
installation site, selecting
, 2-3
interfaces
connecting serial cable to access user
, 3-11
L
LAN,connecting unit to, 3-12
LEDs
reading system
, 2-6
loopback, plugs for
, B-9
M
MAX TNT
backpanel
, 2-5
connecting to LAN
, 3-12
connecting to workstation
, 3-11
features
, 1-1
general specifications
, C-1
installing slot cards
, 3-15
installing the chassis
, 3-1
interpreting shelf controller LEDs
, 2-6
powering on
, 3-14
shelf
, 1-2
supported slot cards
, 1-2
WAN switched services available
, B-9
MultiDSP cards
96-port card
, A-18
N
nailed channels
HDLC resources and
, A-17
O
OC3 ATM card, A-20
specifications
, A-20
status lights
, A-21
P
PCMCIA card
danger removing
, 3-13
verifying integrity of
, 3-14
power