3-18 MAX TNT Hardware Installation Gulide
Installing a MAX TNT Chassis
Installing or replacing slot cards
3 Using a number 2 Phillips screwdriver, tighten the jack screw as shown in Figure 3-17 to
fully seat the card.
4 Loosen the jack screw one-half turn so that the slot card panel is free to allow the lock
screw to self-align.
5 Using a number 2 Phillips screwdriver, tighten the lock screw (on the left side of the card,
as shown in Figure 3-17).
6 Finish tightening the jack screw.
All MAX TNT slot cards are hot-swappable, which means that you can safely insert or remove
cards while power is on.
Note: Be sure to install blank single-slot filler cards in any unused slots to ensure proper
airflow.
Removing slot cards
To remove slot cards from the MAX TNT chassis proceed as follows:
!
Caution: Failure to follow this procedure can result in damage to the card or chassis.
1 Using a number 2 Phillips screwdriver, loosen the lock screw (on the left side of the card,
as shown in Figure 3-17) with three turns.
2 Using a number 2 Phillips screwdriver, loosen the jack screw with three turns
counterclockwise.
3 Repeat step 1 and step 2 until both screws disengage, then remove the slot card.
To Next Page
Loading...
