BA053101-en
Pos: 363 /Tech nische D okumen tation/A lle G eräte/ Überschr iften/Üb ers chrifte n 1.1.1/O/ Über schrift 1.1.1: OBD-E instel lun gen (Opt ion) @ 13\ mod_1234866299158_75.docx @ 341321 @ 3 @ 1
Pos: 364 /Te chnis che D okum ent ati on/ Leis tun gsm esst ech nik/ POWE R DYN O/0 523 01 LPS 3 000 R10 0/B A/I nhal t: 052 3 OBD -Eins tellun gen (Opti on) @ 13\mod_1234866365827_75.docx @ 341347 @ @ 1
Use the menu point OBD settings to select and display the measurement data. The measurement
data supplied by the diagnostic interface vary depending on the vehicle manufacturer.
1 Use the menu point OBD-SETTINGS.
⇒ The following window opens.
2 Connect the OBD plug with the diagnostic
interface.
3 Start the engine and let it run in idle.
4 Confirm with <COMPLETED>.
After communication has been set up, the OBD
symbol appears green in the status line.
Following screen appears:
5 Select the desired measurement values for
Channel 1 to 4 from the list.
6 Use <F8 IMPORT> to accept the settings.
If the communication cannot be set up the first time, wait approx. 10 seconds and repeat the pro-
cedure. switch off the ignition and separate the reading device from the diagnostic interface. Then
repeat step 1 – 4.
Pos: 365 /-----F ormat- ----/MA NUELLE R UMBR UCH Seitenum bruch @ 0\mod_1134403577687_0.docx @ 1277 @ @ 1
To Next Page
Loading...
Need help?
General
