3 - 12
1
Â
10H - DAILY MAINTENANCE OR EVERY 10 HOURS OF SERVICE
CHECK General inspection
IMPORTANT
Consult the maintenance personnel if there is doubt about the condition of the platform.
NOTE: The turntable covers must be open and the battery cover
1
must be removed
to carry out the general inspection of the platform. They must be put back in
place and closed once finished.
The operator must perform a visual and physical inspection of the platform:
- Check that the instructions for use are clean and complete.
- Check the stickers and make sure they are all present, clean and legible,
2-DESCRIPTION: STICKERS.
- Check for the absence of leaks: fuel, engine oil, coolant, battery liquid, hydraulic
oil, lubricants, etc.
- Check the condition of the structure: absence of impacts, damage, cracked welding,
corrosion, excessive mechanical play, wear, etc.
- Check the condition of the basket: structure, floor, safety rail, harness attachment
points, etc.
- Check the condition of the hydraulic components: pumps, distributors, valves,
motors, cylinders, hoses, etc.
- Check the condition of the mechanical components: wheels, tyres, tie rods, crown
gear, shafts, etc.
- Check the condition of the electrical components: control panels, pedal switch,
control handles, switches, buttons, indicator lights, battery, fuses, cables, harnesses,
rotating beacon light, etc.
- Check the condition of covers, handles, locks, plugs, etc.
- Check there are no parts missing or loose: screws, nuts, pins, etc.
- Check that no parts are missing or have had unauthorised modifications.
- Check the general cleanliness of the platform: basket floor, motor compartment,
etc.
CHECK Fuel level
CHECK Battery voltage
IMPORTANT
Never smoke or approach with a flame when filling with fuel or when the tank cap has been removed.
Never fill up with fuel while engine is running.
If there is doubt about the battery voltage, refer to the maintenance personnel.
- Switch on the access platform.
- Check the fuel level displayed on the interface screen.
- If the level is low:
• Remove the cap from the tank
1
.
• Add fuel until the maximum level is reached, LUBRICANTS AND FUEL.
• Refit the tank cap.
- If the level is correct:
• Ensure that the tank cap
1
is correctly closed.
- Check the battery voltage displayed on the interface screen. Refer to the maintenance
personnel if the voltage is low.
- Switch off the power to the access platform.
1
To Next Page
Loading...
Need help?
General
