AXLES/DRIVE SHAFTS/WHEELS AND TIRES CD3340B/YB4411
8-30
Published 04/07/2015 Control # 569-00
4. Secure the swivel housing with a rope and hoist
(Figure 8-121).
NOTE: Be sure the swivel housing is securely fastened
before lifting it in place. Possible personal injury
could result from a falling swivel housing.
Lubricate the lips of the ring seal. Tape the splined
end of the axle shaft to protect the ring seal during
installation of the swivel housing. Install the swivel
housing to the axle beam.
Position the upper and lower king pins to the swivel
housing. Install the mounting screws and tighten to
a torque of 190 Nm (140 lb-ft).
Be sure the Belleville washers remain in position.
5. Place the wheel hub on a workbench and install the two
taper roller bearing cups with SPECIAL TOOL P/N
1901774 and a press or hammer (Figure 8-122).
Apply sealing compound on the ring seal outer surface
and install the ring seal in the wheel hub with SPECIAL
TOOL P/N 1901774 and a hammer.
6. Install the bearing cone on the swivel housing end
(Figure 8-123).
Install the wheel hub on the swivel housing and then
install the other bearing cone in position.
7. Place the wheel carrier on a workbench and install the
bushings (Figure 8-124) level to the carrier surface
using SPECIAL TOOL P/N 19001776.
At least two bushings (diametrically opposed) should be
set slightly higher than the carrier surface to be used as
dowel pins.
8. Pre-assemble the wheel carrier, epicyclic ring gear with
the special lock ring (X) shown in Figure 8-125.
Reference Only
To Next Page
Loading...
