S
ection
4
SECTION 4 • INSTALLATION
GENERAL
The DVR2000E is delivered in a sturdy carton to prevent shipping damage. Upon receipt, check the part number
against the requisition and packaging list for agreement. Inspect for damage, and if there is evidence of such,
immediately le a claim with the carrier and notify your sales representative or a sales representative at Marathon
Electric.
If the unit is not installed immediately, store it in the original shipping package in a moisture and dust free
environment.
MOUNTING
The DVR2000E is normally located in the generator conduit box. It is designed for behind the panel mounting
and requires a cutout for front panel viewing and access. Mounting hardware consists of six customer supplied,
#12 thread-forming screws that pass through mounting holes in the conduit box and thread into the plastic shell
of the DVR2000E. The unit must be mounted where the ambient temperature does not exceed the allowable
environmental conditions called out in Section 1, General Information, Specications. DVR2000E package
dimensions are shown in Figure 4-1. Cutout and drilling dimensions are shown in Figure 4-2.
26
3
Main Index
5
Section 4 Index
27
3
Main Index
5
Section 4 Index
To Next Page
Loading...