Chapter 6 Chassis section 6 Rear wheels
6—31
Rear sprocket
Tighten rear sprocket nut to specified torque.
Rear sprocket nut: 50 N · m (5.0 kg · m)
Note:
The imprint marks on the sprocket face
outward.
As in Fig.5.6.16.
The rear wheel
Adjust the tightness of the drive chain after installing the
rear wheel.
Tighten rear axle nut 1 to specified torque.
Rear axle nut: 78 N · m (7.8 kg · m)
Tighten the two chain adjusting nuts .②
Adjust foot brake free stroke.
As in Fig.5.6.17
Fig.5.6.16
Fig.5.6.17
Note:
First assemble the right wheel bearing, then assemble the left wheel bearing.
The seal cover on the bearing must be outward facing.
Fig 5.6.15
To Next Page
Loading...
