Mash Seventy - Section 4 Inspection of Oil Pressure

Chapter 2
Periodic maintenance
Section 3 Inspection of oil pressure
2
—
20
Section 4 Inspection of oil pressure
Regularly check the oil pressure to keep the moving
parts of the motorcycle in good condition.
Oil pressure technical specification
When 2000 rpm, in cold state
Above 0.01MPa
Under 0.03MPa
If the oil pressure is lower or higher than the above
requirements, the following reasons should be considered:
Low oil pressure:
The oil filter is clogged;
Oil leakage; O-ring is damaged;
The oil pump is malfunctioning;
The comprehensive reasons for the above.
High oil pressure
Engine oil viscosity is too high;
The oil circuit is blocked;
The comprehensive reasons for the above.
Oil pressure check steps
Check the oil pressure as follows:
Install the oil pressure gauge at the position shown in the
figure; as shown in Fig. 2.4.1.
Connect the electronic tachometer;
In the cold engine state, increase the engine speed to 2000
rpm and read the oil pressure gauge.
Fig.2.4.1