Chapter 8 Information service Section 1Troubleshooting
8-3
MALFUNCTION
CODE
DETECTED
ITEM
DETECTED FAILURE CONDITION
CHECK FOR
P0336
CKP
Noisy
Signal
After engine running, if the magneto rotor tooth’s error is
happenedcontinuouslyby10timesin100timestestcycle,the code P0336
is indicated.
CKP wiring and mechanical parts.(CKP lead wire coupler connection)
P0335
No
Signal
After engine running, if the CKP signal does not reach ECU for more
than 0.5 sec., the code P0337 is indicated.
CKPwiringandmechanicalparts.(CKP,leadwire couplerconnection)
P0500
Speed sensor
Malfunction
Motorcycle speed＜10km/h
Water temperature＜20℃
IAP&TS pressure＞40kpa
20%＜TPS open angle＜100%
2,000rpm＜Engine speed ＜6,000rpm
If the above conditions are maintained for 32.5sec.and more,
The code P0500 is indicated
Speedo sensor, wiring/coupler connection to ECU
P0505
ISC Error
After engine running, if idle speed is different to 500 rpmfrom
thespecifiedrangein25secondstestcycle,thecodeP0505isindicated
Idle speed control solenoid, wiring / coupler connection.
P0562
Battery
Voltage
Low
The battery voltage should be the following9 V ≤Batteryvoltage.
Without the above range for3.125sec.andmore,P0562is indicated.
Battery, wiring / coupler connection to ECU.
P0563
High
The battery voltage should be the following.Battery voltage
≤16V.Without the above range for 3.125 sec.andmore,P0563is
indicated.
Battery, wiring / coupler connection to ECU.
P0601
ECU Fault
When ML on The ECU will check malfunction code, if there’s
ECU error the code P0601 is indicated.
The fuel injection will be cut off AccordinglyECU
P0650
Engine warning
lampCircuit
Malfunction
After engine running, if “FI” check lamp signal open or is happened
the high / ground short fault for 1 second by 40 times in 80 times test
cycle, the code P0650 is indicated.
“FI” check lamp, wiring / coupler connection.
P0850
GPorClutchlever
Switch
CircuitMalfunction
If gear position or clutch lever switch signal feedback is not active in
continuous by 20 times in fully power down cycles, the code P
indicated.
(Fully power down cycle : Ignition switch “ON” “OFF” position)
Gearpositionorclutchleverswitch,wiring/couplerconnection, gearshift
cametc.
To Next Page
Loading...
