Mash Seventy - Page 34

Chapter 2
Periodic maintenance
Section 2 Maintenance and adjustment
2
—
16
Tire tread condition
The use of over worn tires will reduce driving stability
and cause dangerous situations. It is especially
recommended to replace the tire when the remaining depth
of the tread reaches the following specifications.
Check the tire tread depth with using the tire depth
gauge.
Tire tread depth limit (front): 1.6mm
(Rear): 1.6mm
As in Fig.2.2.44
Tire pressure
If the tire pressure is too high or too low, steering will
be blocked and tire wear will increase.Therefore, the
correct tire pressure must be maintained to obtain good
driving stability and prolong the life of the tire.
The inflation pressure in the cold condition is as
following table:
As in Fig.2.2.45
Note：The standard tires assembled on this motorcycle：
Front tire：90/90-17 Rear tire：100/90-17
Using tires other than standard tires may cause
unstable driving. It is particularly recommended to use
the specified tires.
Exhaust pipe bolts and silencer mounting bolts
Tightening should be performed
during the first 1000 kilometers (5 months)
and every 4000 kilometers (20 months)
thereafter.
Use a torque wrench to tighten the exhaust pipe
bolt ① and the silencer bolt②.As in Fig.2.2.46.
Exhaust pipe bolt ①: 11 N.m (1.1 kg.m)
Fig.2.2.44
Fig.2.2.45
Fig.2.2.46