Mash Seventy - Page 58

Chapter 3 Engine Section 4 Inspection and maintenance of engine componenets
3—20
Remove the right box bearing.
As in Fig.3.4.6
Install the left box bearing and use special tools to
assemble the bearing.
The driving shaft bearing is installed, and the washer
is installed.①
Add a small amount of super grease to the oil seal.
Use special tooling to seal oil.
As in Fig.3.4.7
Install the left box bearing baffle②..
As in Fig.3.4.8
Note:
Add a small amount of thread sealant to the
bearing cage screws
Install the right box bearing
Use special tools to assemble bearings.
Install intermediate bearing baffle③..
As in Fig.3.4.9
Fig.3.4.6
Fig.3.4.7
1
Fig.3.4.8
2
Fig.3.4.9
3
Note:
Apply a small amount of thread sealant to the
bearing cage screws