140
Controls in detail
Memory function
Prior to operating the vehicle, the driver
should check and adjust the seat height,
seat position fore and aft, and seat back-
rest angle if necessary, to ensure ade-
quate control, reach and comfort. The
head restraint should also be adjusted
for proper height. See also the section on
airbags (
컄 page 83) for proper seat posi-
tioning.
In addition, adjust the steering wheel to
ensure adequate control, reach, opera-
tion and comfort. Both the inside and
outside rear view mirrors should be ad-
justed for adequate rear vision.
Fasten seat belts. Infants and small chil-
dren should be seated in a properly se-
cured restraint system that complies with
U.S. Federal Motor Vehicle Safety Stan-
dard 213 and 225 and Canadian Motor
Vehicle Safety Standard 213 and 210.2.
With the memory function you can store
up to five different settings.
Each stored position on the driver’s side
includes the following settings:
앫 Driver’s seat, backrest and head re-
straint position
앫 Multicontour seat: previously saved
setting
앫 Steering wheel position
앫 Interior rear view mirror position
앫 Exterior rear view mirrors position
Each stored position on the front passen-
ger side and in the rear passenger com-
partment includes the following
settings:
앫 Front and rear outer seats, backrest
and head restraint positions
앫 Multicontour seats: previously saved
settings
The memory button and stored position
buttons are located on the respective
door.
Example illustration from Maybach 57
1 Memory button M
2 Memory position buttons 1 - 5
왘 Switch on the ignition (컄 page 60).
or
왘 Open the respective door.
Memory function
Warning! G
Do not activate the memory function while
driving. Activating the memory function
while driving could cause the driver to lose
control of the vehicle.
To Next Page
Loading...
