196
Controls in detail
Automatic climate control
The automatic climate control switches
automatically to the following functions:
앫 maximum blowing and heating
power (depends on cooling tem-
perature)
앫 air flows onto the windshield and
the front side windows
앫 cooling on to dehumidify
앫 the air recirculation mode is
switched off
Deactivating
왘 Press button P (컄 page 193).
The indicator lamp on the button
goes out. Defrosting is turned off.
Windshield fogged on the outside
왘 Switch the windshield wipers on.
왘 Press one button U.
The indicator lamp on the button
comes on. The air volume and air dis-
tribution are adjusted automatically.
i In automatic mode, the automatic climate
control is regulated to prevent the windows
from fogging up.
If the left and right air distribution con-
trols as well as the air volume control are
set to U and there is a high need for
cooling, the display
AUTO MAXCOOL
ap-
pears.
This provides the fastest possible cooling
of the vehicle interior (when windows
and tilt/sliding sunroof are closed).
i These settings should only be selected for
a short time.
Switch to air recirculation mode to pre-
vent unpleasant odors from entering the
vehicle from the outside (e.g. before
driving through a tunnel). This setting
cuts off the intake of outside air and re-
circulates the air in the passenger com-
partment.
컄컄
Maximum cooling MAXCOOL Air recirculation mode
Warning! G
Fogged windows impair visibility, endan-
gering you and others. If the windows be-
gin to fog on the inside, switching off the
air recirculation mode immediately should
clear interior window fogging. If interior
window fogging persists, make sure the air
conditioning (컄 page 208) is activated, or
press button P.
To Next Page
Loading...
