EasyManua.ls Logo

MAYBACH 62 S - Synchronizing the Power Tilt;Sliding Sunroof (Maybach 57)

Default Icon
466 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
213
Controls in detail
Power tilt/sliding sunroof
! Please keep in mind that weather
conditions can sometimes change rapidly.
Make sure to close the tilt/sliding sunroof
when leaving the vehicle. If water enters the
vehicle interior, vehicle electronics could be
damaged which is not covered by the
Maybach Limited Warranty.
i When the tilt/sliding sunroof is open, res-
onance noises may result in addition to the
usual wind noises. They are caused by minimal
pressure changes in the passenger compart-
ment. To reduce or eliminate these noises,
change the position of the tilt/sliding sunroof
or open a side window slightly.
i You can also open or close the tilt/sliding
sunroof using the SmartKey, see “Summer
opening feature” ( page 211) and “Conve-
nience closing feature” ( page 211).
Depending on current position, the tilt/sliding
sunroof may also open or close when the air
recirculation button , or the charcoal filter
button e ( page 193) is pressed and held
for 2 seconds.
i With the SmartKey in starter switch posi-
tion 0 or removed from the starter switch, the
tilt/sliding sunroof can be operated
until you open the driver’s or passenger
door
for up to approximately 5 minutes
Switch on the ignition ( page 60).
Opening and closing the power tilt/slid-
ing sunroof
To open, close, raise or lower the tilt/
sliding sunroof, move the switch to
the resistance point in the required
direction 1 to 4.
Release the sunroof switch when the
tilt/sliding sunroof has reached the
desired position.
Fully opening (Express-open) and clos-
ing (Express-close) the power tilt/sliding
sunroof
To open, close, raise or lower the tilt/
sliding sunroof, move the switch past
the resistance point in the required
direction 1 to 4 and release.
The tilt/sliding sunroof opens or clos-
es completely.
Stopping the power tilt/sliding sunroof
Move the switch in any direction.
i If the movement of the tilt/sliding sunroof
is blocked during the closing procedure, the
sunroof will stop and reopen slightly.
The tilt/sliding sunroof must be synchro-
nized
after the consumer battery has been
disconnected
the tilt/sliding sunroof has been
closed manually
a malfunction
the tilt/sliding sunroof does not open
smoothly
Remove the respective fuse from the
fuse box (
page 426).
Reinsert the fuse in the main fuse
box.
Switch on the ignition ( page 60).
Move and hold the sunroof switch in
direction of arrow 4 until the tilt/
sliding sunroof is fully raised at the
rear.
Keep holding the sunroof switch in
direction of arrow 4 for approxi-
mately 1 second.
Check the Express-open feature.
If the tilt/sliding sunroof opens com-
pletely, the roof is synchronized. Oth-
erwise repeat the above steps.
Synchronizing the power tilt/sliding
sunroof (Maybach 57)

Table of Contents

Related product manuals