EasyManua.ls Logo

MAYBACH 62 S - Setting the Temperature; Adjusting Air Distribution; Adjusting Air Volume; Front Defroster

Default Icon
466 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
195
Controls in detail
Automatic climate control
Use temperature controls 4 for the
driver’s side or 6 (
page 193) for the
passenger side to separately adjust the
air temperature on each side of the pas-
senger compartment. You should raise
or lower the temperature setting in small
increments, preferably starting
at 72°F (22°C).
Increasing
Push top of temperature control 4
and/or 6 until the display shows the
desired temperature.
The automatic climate control system
will adjust the interior air tempera-
ture accordingly.
Decreasing
Push bottom of temperature
control 4 and/or 6 until the display
shows the desired temperature.
The automatic climate control system
will adjust the interior air tempera-
ture accordingly.
Use the air distribution controls 2
and 8 (
page 193) to separately adjust
the air distribution on each side of the
passenger compartment. The following
symbols are located on the controls:
Press air distribution control 2 for
the driver’s side and/or 8 for the
passenger side (
page 193).
The indicator lamp on button U
goes out.
The air volume is controlled automat-
ically while the air distribution is con-
trolled manually in the respective
zone.
The selected air distribution is shown
in the display 5 (
page 193).
Seven blower speeds are available.
Press to decrease or Q to in-
crease air volume to the desired level.
The indicator lamp on button U
goes out.
The air volume is controlled manually
while the air distribution is controlled
automatically in the respective zone.
The selected blower speed is shown in
the display 5 (
page 193).
You can use this setting to defrost the
windshield, for example if it is iced up.
You can also defog the windshield and
the side windows.
i Keep this setting selected only until the
windshield or the side windows are clear
again.
Activating
Press button P ( page 193).
The indicator lamp on the button
comes on.
Setting the temperature Adjusting air distribution
Symbol Function
Ô Directs air to the windows
Ø Directs air to the windows,
footwells, center and side air
vents
Ó Directs air to the footwell air
vents
Õ Directs air to the center and
side air vents
Adjusting air volume
Front defroster
컄컄

Table of Contents

Related product manuals