142
Controls in detail
Lighting
For information on how to switch on the
headlamps and use the turn signals,
see “Switching on headlamps”
(
컄 page 73) and “Turn signals”
(
컄 page 74).
i If you drive in countries where vehicles
drive on the other side of the road than the
country where the vehicle is registered, you
must have the headlamps modified for sym-
metrical low beams. Relevant information can
be obtained at an authorized Maybach
Studio.
i The active Bi-Xenon headlamps monitor
your steering angle and driving speed, then
automatically shift their beams to either side
to better follow the curvature of the road
ahead, increasing usable illumination over
conventional headlamps.
Exterior lamp switch
Lighting
Exterior lamp switch
1 ‚ Standing lamps, left (turn left
two stops)
2 ˆ Standing lamps, right (turn
left one stop)
3 M Off
Daytime running lamp mode
(
컄 page 144)
4 U Automatic headlamp mode
Daytime running lamp mode
(
컄 page 144)
5 C Parking lamps (also side
marker lamps, tail lamps, li-
cense plate lamps, instru-
ment panel lamps)
6 B Low beam headlamps or high
beam headlamps when the
combination switch is pushed
forward. The tail lamps, li-
cense plate lamps, side mark-
er lamps, parking lamps and
instrument panel lamps also
come on.
7 ‡ Front fog lamps
8 † Rear fog lamp
To Next Page
Loading...
