MAYBACH 62 S - Hazard Warning Flasher

147
Controls in detail
Lighting
i The corner-illuminating lamps will come
on automatically depending on the steering
angle, even if you did not switch on either
turn signal.
If the corner-illuminating lamps came on au-
tomatically, they will also go out automatical-
ly depending on the steering angle.
Switching off the corner-illuminating
lamps
The combination switch for the turn sig-
nal resets automatically after major
steering wheel movements. This will
switch off the corner-illuminating lamps
if they were activated by switching on
the left or right turn signal.
If the turn signal should stay on after
making the turn, the turn signal and cor-
ner-illuminating lamp can be switched
off by returning the combination switch
to its original position.
i There may be a brief delay before the cor-
ner-illuminating lamps switch off.
Driving in reverse
Switching on corner-illuminating lamps
왘 Place the gear selector lever in
position R.
The corner-illuminating lamp oppo-
site to your steering direction comes
on.
Switching off corner-illuminating lamps
왘 Place the gear selector lever out of
position R.
The respective corner-illuminating
lamp goes out.
The hazard warning flasher can be
switched on at all times, even with the
SmartKey or SmartKey with
KEYLESS-GO** removed from the starter
switch or with the SmartKey with
KEYLESS-GO** removed from the vehi-
cle.
The hazard warning flasher switches on
automatically when an airbag deploys.
The hazard warning flasher switch is lo-
cated on the upper part of the front cen-
ter console.
1 Hazard warning flasher switch
Hazard warning flasher