MAYBACH 62 S - Engine Oil

309
Operation
Engine compartment
The amount of oil your engine needs will
depend on a number of factors, includ-
ing driving style. Higher oil consumption
can occur when
앫 the vehicle is new
앫 the vehicle is driven frequently at
higher engine speeds
Engine oil consumption checks should
only be made after the vehicle break-in
period.
! Do not use any special lubricant additives,
as these may damage the drive assemblies. Us-
ing special additives not approved by us for
use on Maybach vehicles may cause damage
not covered by the Maybach Limited
Warranty.
More information on this subject is available
at any Maybach Studio.
Checking engine oil level with the con-
trol system
When checking the oil level
앫 the vehicle must be parked on level
ground
앫 with the engine at operating temper-
ature, the vehicle must have been sta-
tionary for at least 5 minutes with the
engine turned off
앫 with the engine not at operating
temperature yet, the vehicle must
have been stationary for at least
30 minutes with the engine turned
off
You can check the engine oil level on the
multifunction display.
왘 Switch on the ignition (컄 page 60).
The standard display (
컄 page 162)
should appear in the multifunction dis-
play.
왘 Press button k or j on the
steering wheel until the following
message is seen in the multifunction
display:
One of the following messages will
subsequently appear in the indicator:
앫 ENGINE OIL LEVEL
OK
앫 ADD 1.0 QTS. TO
REACH MAX. OIL LEVEL
(Canada: 1.0 LITER )
앫 ADD 1.5 QTS. TO
REACH MAX. OIL LEVEL
(Canada: 1.5 LITERS )
앫 ADD 2.0 QTS. TO
REACH MAX. OIL LEVEL
(Canada: 2.0 LITERS )
i If you want to interrupt the checking pro-
cedure, press button k or j on the mul-
tifunction steering wheel.
왘
If necessary, add engine oil.
For adding oil (컄 page 310).
For more information on engine oil, see
“Technical data” (
컄 page 440) and
(
컄 page 441).
Other display messages
If the ignition is not switched on, the fol-
lowing message will appear:
FOR ENGINE OIL LEVEL
SWITCH IGNITION ON
왘 Switch on the ignition.
If you see the message:
PERFORM SERV ON TIME
왘 If engine is at operating temperature,
wait 5 minutes before repeating
check procedure.
Engine oil
컄컄