141
Controls in detail
Memory function
왘 Adjust the seats, steering wheel and
mirrors to the desired position
(
컄 page 62).
왘 On the driver’s side: adjust the steer-
ing wheel (
컄 page 64) and the rear
view mirrors (
컄 page 66) to the de-
sired position.
왘 Press memory button M.
왘 Release memory button M and push
memory position button 1, 2, 3, 4 or 5
within 3 seconds.
All the settings are stored at the se-
lected position.
! Do not operate the power seats using the
memory button if the seat backrest is in an ex-
tremely reclined position. Doing so could
cause damage to front or rear seats.
First move seat backrest to an upright posi-
tion.
왘
Press and hold memory position
button 1, 2, 3, 4 or 5 until the seat,
steering wheel and mirrors have fully
moved to the stored positions.
i Releasing the button immediately stops
movement to the stored positions.
For easier parking you can adjust the pas-
senger exterior rear view mirror so that
you can see the right rear wheel as soon
as you engage reverse gear R.
For information on activating the park-
ing position, see “Activating exterior
rear view mirror parking position”
(
컄 page 187).
The buttons are located on the driver’s
door.
1 Exterior rear view mirror (passenger-
side)
2 Adjustment button
3 Memory button M
왘 Stop the vehicle in a safe location.
왘 Make sure the ignition is switched on
(
컄 page 60).
왘 Press button 1.
The passenger-side exterior rear view
mirror is selected.
왘 Adjust the exterior rear view mirror
with button 2 so that you see the
rear wheel and the road curb.
왘 Press memory button 3.
왘 Within 3 seconds, press bottom of ad-
justment button 2.
The parking position is stored if the
mirror does not move.
i If the mirror does move, repeat the above
steps. After the setting is stored, you can
move the mirror again.
Storing positions in memory
Recalling positions from memory
Storing exterior rear view mirror
parking position
To Next Page
Loading...