210
Controls in detail
Power windows
왘 Switch on the ignition (컄 page 60).
Opening the windows
왘 Press switch 1 to 4 at the
symbol k to resistance point.
The corresponding window will move
downwards until you release the
switch.
Closing the windows
왘 Press switch 1 to 4 at the
symbol j to resistance point.
The corresponding window will move
upwards until you release the switch.
Fully opening the windows
(Express-open)
왘 Press switch 1 to 4 at the
symbol k past the resistance point
and release.
The corresponding window opens
completely.
Fully closing the windows
(Express-close)
왘 Press switch 1 to 4 at the
symbol j past the point of resis-
tance and release.
The corresponding window closes
completely.
! If the upward movement of the window
is blocked during the closing procedure, the
window will stop and open slightly.
Remove the obstruction, press the respective
power window switch at the symbol j
again past the resistance point and release.
If the window still does not close when there
is no obstruction, press and hold the respec-
tive power window switch at the symbol j.
The window will then close without the ob-
struction sensor function.
Stopping the power windows during Ex-
press-operation
왘 Briefly press the respective power
window switch again.
The windows must be synchronized
앫 after the consumer battery has been
disconnected
앫 if the windows cannot be fully
opened (Express-open) or closed
(Express-close)
Each window must be synchronized.
왘 Switch on the ignition (컄 page 60).
왘 Press and hold the power window
switches at the symbol j until the
windows are completely closed.
왘 Keep pressing the switches for ap-
proximately 1 second.
The windows are synchronized.
Warning! G
If you press and hold the switch up when
closing the window, and upward move-
ment of the window is blocked by some
obstruction including but not limited to
arms, hands, fingers, etc., the automatic
reversal will not operate.
Warning! G
Driver’s door only: If within 5 seconds you
again press the switch past the resistance
point and release, the automatic reversal
will not function.
Synchronizing the power windows
To Next Page
Loading...
