124
Controls in detail
Locking and unlocking
Opening the trunk from the outside
1 Handle
왘 Press and hold button Š on the
SmartKey or SmartKey with
KEYLESS-GO** until the trunk un-
locks and begins to open.
or
왘 Pull on handle 1.
In vehicles without KEYLESS-GO**:
The vehicle must be unlocked.
! To stop the opening procedure, press
button Š on the SmartKey or SmartKey
with KEYLESS-GO**.
i If the trunk does not open, it is still locked
separately (컄 page 127).
Opening the trunk from the inside
1 Remote trunk opening/closing switch
왘 Pull switch 1 until the trunk lid
begins to open.
The trunk opens. You will see the
symbol Ê in the multifunction dis-
play until you close the trunk.
! To stop the opening procedure, press or
pull trunk opening/closing switch 1.
i If the trunk does not open, it is still locked
separately (컄 page 127).
i Do not place the SmartKey in the open
trunk. You may lock yourself out.
i If the vehicle was previously centrally
locked, the trunk will lock automatically after
closing it. All turn signal lamps flash three
times to confirm locking.
Vehicles with KEYLESS-GO**: To prevent a
possible inadvertent lockout, the trunk will
open automatically if a SmartKey with
KEYLESS-GO** is recognized inside the vehicle
or in the trunk.
The vehicle is only locked when the turn sig-
nals flash three times. If you are carrying a sec-
ond SmartKey with KEYLESS-GO** with you,
you can still lock the vehicle.
If the trunk lid comes into contact with an ob-
ject while closing (e.g. luggage that has been
piled too high) in the upper motion sequence,
the closing procedure is stopped and the
trunk re-opens slightly.
Closing the trunk
Warning! G
Make sure the trunk is closed when the en-
gine is running and while driving. Among
other dangers, such as blocked visibility,
exhaust fumes may enter the vehicle inte-
rior. These fumes are damaging to your
health.
To Next Page
Loading...
