MAYBACH 62 S - Turn Signals; Windshield Wipers

74
Getting started
Driving
High beam
The combination switch is located on the
left of the steering column.
Combination switch
1 High beam
2 High beam flasher
왘 Push combination switch in direction
of arrow 1.
The high beam headlamps and the
high beam headlamp indicator
lamp A in the instrument cluster
come on (
컄 page 22).
For more information on headlamps,
see “Lighting” (
컄 page 142).
The combination switch is located on the
left of the steering column.
Combination switch
1 Turn signal, right
2 Turn signal, left
왘 Press combination switch in direction
of arrow 1 or 2.
The corresponding turn signal indica-
tor lamp L or K in the instru-
ment cluster flashes (
컄 page 22).
The combination switch resets automati-
cally after major steering wheel move-
ments.
i To signal minor directional changes such
as changing lanes, press combination switch
only to point of resistance and release. The
corresponding turn signals will flash three
times.
The combination switch is located on the
left of the steering column.
Combination switch
1 Single wipe
Wiping with windshield washer fluid
2 Switching on windshield wipers
왘 Switch on the ignition (컄 page 60).
! Do not operate the windshield wipers
when the windshield is dry. Dust that accumu-
lates on a windshield might scratch the glass
and/or damage the windshield wipers blades
when wiping occurs on a dry windshield. If it
is necessary to operate the windshield wipers
in dry weather conditions, always operate the
windshield wipers with windshield washer flu-
id (컄 page 75).
Turn signals Windshield wipers