236
Controls in detail
Driving systems
1 Vehicle level control button
2 Indicator lamp
왘 Start the engine.
왘 Briefly press button 1 to change
from one level setting to the other.
The message:
AIRMATIC
VEHICLE RISING
appears for approximately
10 seconds in the multifunction dis-
play when changing from normal lev-
el to raised level. The indicator
lamp 2 is then on.
왘 Press button 1 again to lower the
vehicle. The indicator lamp 2 is off.
The selected vehicle level setting remains
stored in memory even if the engine is
turned off and restarted except when
you
앫 exceed a speed of 75 mph (120 km/h)
or
앫 maintain a speed of between 50 mph
(80 km/h) and 75 mph (120 km/h) for
more than 5 minutes
The vehicle then lowers to normal level.
The indicator lamp 2 goes out.
The vehicle chassis ride height is raised or
lowered according to the selected level
setting and to the vehicle speed:
앫 Normal level (Maybach 57,
Maybach 62): At a speed exceeding
approximately 68 mph (110 km/h),
the ride height is reduced automati-
cally (
컄 page 235).
앫 Raised level: At a speed exceeding ap-
proximately 75 mph (120 km/h), the
ride height is reduced automatically
(
컄 page 235).
앫 With decreasing speed, the ride
height is again raised to the normal
level.
i These height adjustments are so small
that you may not notice any change.
Select the raised level only when re-
quired by current driving conditions.
Otherwise
앫 handling may be impaired
앫 fuel consumption may increase
To Next Page
Loading...
