290
Controls in detail
Useful features
Programming or reprogramming the
integrated remote control
Step 1:
왘 Switch on the ignition (컄 page 60).
Step 2:
왘 If you have previously programmed a
signal transmitter button and wish to
retain its programming, proceed to
step 3.
If you are programming the integrat-
ed remote control for the first time,
press and hold the two outer signal
transmitter buttons 3 and 4 and re-
lease them only when indicator
lamp 1 begins to flash after approx-
imately 20 seconds (do not hold the
button for longer than 30 seconds).
This procedure erases any previous
settings for all three channels and ini-
tializes the memory.
If you later wish to program a second
and/or third hand-held transmitter to
the remaining two signal transmitter
buttons, do not repeat this step and
begin directly with step 3.
Step 3:
왘 Hold the end of hand-held remote
control 5 of the device you wish to
train approximately 2 to 5 in
(5 to 12 cm) away from the signal
transmitter button (2, 3 or 4) to be
programmed, while keeping indica-
tor lamp 1 in view.
Step 4:
왘 Using both hands, simultaneously
press hand-held remote control but-
ton 6 and the desired signal trans-
mitter button (2, 3 or 4). Do not
release the buttons until step 5 is
completed.
Indicator lamp 1 will flash, first slow-
ly and then rapidly.
i Indicator lamp 1 flashes immediately the
first time the signal transmitter button is pro-
grammed. If this button has already been pro-
grammed, the indicator lamp will only start
flashing after 20 seconds.
Step 5:
왘 After indicator lamp 1 changes from
a slow to a rapidly flashing light, re-
lease the hand-held remote control
button and the signal transmitter
button.
Step 6:
왘 Press and hold the just-trained signal
transmitter button (2, 3 or 4) and
observe indicator lamp 1.
If indicator lamp 1 stays on constant-
ly, programming is complete and
your device should activate when the
respective signal transmitter button
(2, 3 or 4) is pressed and released.
i If indicator lamp 1 flashes rapidly for
about 2 seconds and then turns to a constant
light, continue with programming steps 8
through 12 as your garage door opener may
be equipped with the “rolling code” feature.
Step 7:
왘 To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
To Next Page
Loading...
