292
Controls in detail
Useful features
왘 While still holding down the signal
transmitter button (2, 3 or 4),
“cycle” your hand-held remote con-
trol button 6 as follows: Press and
hold button 6 for 2 seconds, then re-
lease it for 2 seconds, and again press
and hold it for 2 seconds. Repeat this
sequence on the hand-held remote
control until the frequency signal has
been learned. Upon successful train-
ing, indicator lamp 1 will flash slow-
ly and then rapidly after several
seconds.
왘 Proceed with programming step 5
and step 6 to complete.
i Upon completion of programming the in-
tegrated remote control, make sure you re-
tain the hand-held remote control that came
with the garage door opener, gate operator
or other device. You may need it for use in
other vehicles, for future programming of an
integrated remote control, or simply for con-
tinued use as a hand-held remote control to
operate the respective device in other situa-
tions.
Reprogramming a single signal transmit-
ter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
왘 Switch on the ignition (컄 page 60).
왘 Press and hold the desired signal
transmitter button (2, 3 or 4). Do
not release the button.
왘 Indicator lamp 1 will begin to flash
after 20 seconds. Without releasing
the signal transmitter button, pro-
ceed with programming starting with
step 3.
Operation of integrated remote control
왘 Switch on the ignition (컄 page 60).
왘 Select and press the appropriate inte-
grated signal transmitter button
(2, 3 or 4) to activate the remote
controlled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Erasing the remote control memory
왘 Switch on the ignition (컄 page 60).
왘 Simultaneously press and hold outer
signal transmitter buttons 3 and 4,
for approximately 20 seconds, until
indicator lamp 1 flashes rapidly. Do
not hold for longer than 30 seconds.
The codes of all three channels are
erased.
i If you sell your vehicle, erase the codes of
all three channels.
Programming tips
If you are having difficulty programming
the integrated remote control, here are
some helpful tips:
앫 Check the frequency of the hand-
held remote control 5 (typically lo-
cated on the reverse side of the re-
mote). The integrated remote control
is compatible with radio-frequency
devices operating between
280-390 MHz.
앫 Put a new battery in hand-held re-
mote control 5. This will increase the
likelihood of the hand-held remote
control sending a faster and more ac-
curate signal to the integrated re-
mote control.
컄컄
To Next Page
Loading...
