422
Practical hints
Jump starting
Jump starting should only be performed
on the starter battery. The starter battery
is located in the engine compartment on
the passenger side.
왘 Make sure the two vehicles do not
touch.
왘 Turn off all electrical consumers, ex-
cept hazard warning flashers or work
lights.
왘 Apply parking brake.
왘 Shift gear selector lever to position P.
왘 Open hood (컄 page 307).
1 Negative terminal of charged battery
2 Positive terminal of charged battery
3 Negative terminal of discharged bat-
tery
4 Positive terminal of discharged bat-
tery
왘 Connect positive terminal 2 of the
charged battery with positive
terminal 4 of the discharged battery
with the jumper cable. Clamp cable
to charged battery 2 first.
! Never invert the terminal connections.
왘
Start engine of the vehicle with the
charged battery and run at idle
speed.
왘 Connect negative terminal 1 of the
charged battery with negative
terminal 3 of the discharged battery
with the jumper cable. Clamp cable
to charged battery 1 first.
왘 Start the engine of the disabled vehi-
cle.
Now you can again turn on the electrical
consumers. Do not turn on the lights un-
der any circumstances.
왘 Remove the jumper cables first from
negative terminals 3 and 1 and
then from positive terminals 4
and 2.
You can now turn on the lights.
왘 Have the starter battery checked at
the nearest authorized Maybach
Studio.
To Next Page
Loading...
