To Next Page

To Previous Page

CRIMP DATA ANALYZER

CDA10

REV.01

105

Machine manager

Typical activities:

Quality control and maintenance on part handling systems, in particular:

• Use and evaluation of diagnostic system results;

• Use of the machine in its normal operating conditions and restoration of operation after the

emergency stop switch has tripped;

• If necessary, quality control and taking the necessary quality maintenance measures;

• Cleaning of some parts of the machine (supporting elements, fixing elements);

• Collaboration to perform the following activities:

 Maintenance;

 Troubleshooting and repairs.

Carrying out regular checks/verifications, in particular:

Regular checks/verifications, in particular:

• Seal check of piping;

• Lubrication effectiveness check;

• Check of the state of wear of protective devices;

• Check of the state of wear of cables and flexible hoses;

• Checks for the absence of oil leaks visible around the hydraulic systems, where present;

• Checks for the absence of foreign bodies in the machine work area;

• Operational check on signal lamps;

• Checks of operating pressures and flow rates in the hydraulic, pneumatic where present,

lubrication systems.

Required technical knowledge:

• Knowledge of machine use;

• Knowledge of the lubricants used and the dangers associated with their use;

• Logical search methods for failures and the evaluation of results;

• Ability to organise in order to command and direct the necessary measures to return the

machine to its functional state of use;

• Professional experience on handling systems for special pieces (automatic handling systems,

element handling systems, etc.);

• Basic knowledge of control techniques and pneumatic where present, hydraulic and electric

regulation.

Mecal CDA10 User Manual

Questions and Answers: