CRIMP DATA ANALYZER
CDA10
REV.01
1.6 SAFETY STANDARDS
The requirements, indications, standards and related safety notes described in the various chapters
of the manual are intended to define a series of behaviours and obligations which must be followed
when performing the various activities that constitute the intended use of the machine, aimed at
operations that are safe for personnel, equipment and the surrounding environment.
The safety standards listed are intended for all authorised personnel, instructed and delegated to
perform the various activities and operations of:
• Transport
• Installation
• Operation
• Use
• Management
• Maintenance
• Cleaning
• Decommissioning and dismantling
1.7 MANUFACTURER’S RESPONSIBILITIES
The Manufacturer declines all responsibility deriving from incorrect or improper use of the machine
in question and from any damage caused by the use of non-prescribed spare parts, from
maintenance operations not carried out correctly or from tampering with circuits, components and
system software.
The responsibility concerning the application of safety requirements, reported as follows, is at the
expense of the technical personnel responsible for activities foreseen on the machine. Technical
personnel must ensure that the operators authorised to carry out the required activities are
qualified, that they comply with and are aware of the provisions contained in this document and of
the general safety standards applied to the machine.
Failure to comply with safety standards may result in injury to personnel and damage to equipment.
To Next Page
Loading...
Need help?
General