CRIMP DATA ANALYZER
CDA10
REV.01
2.6.3 PLATES PRESENT ON THE MACHINE
The Manufacturer has installed a series of monitoring plates on the equipment, defined in
accordance with European legislation regarding the graphic symbols to be used. The plates in
question are in a clearly visible position on the machine.
Maintenance service must immediately replace any plates which have become illegible due to wear.
Removing the monitoring plates from the machine is strictly prohibited.
The Manufacturer declines all responsibility for the safety of the machine in
the event of non
-compliance with this prohibition.
concerning the monitoring plates installed on the integrated
machine parts, please see the specific manuals
.
To Next Page
Loading...