CRIMP DATA ANALYZER
CDA10
REV.01
4.2 TRASPORT
Depending on the destination, the machine can be shipped in the following ways:
• BY SEA → the various parts that make up the machine are enclosed in flat bottomed crates and
anchored with tie rods. The crates are lined and have a door for customs checks. They also
contain bags with desiccant salts against moisture and sea salt.
• BY AIR → the various parts that make up the machine are enclosed in flat bottomed crates and
anchored with tie rods. The crates are lined and have a door for customs checks. They also
contain bags with desiccant salts against moisture and other atmospheric agents.
• VIA GROUND→ transport via ground can be divided into two categories:
LONG DISTANCE TRANSPORT, where the various parts of the machinery are covered with
protective sheets, enclosed in flat bottomed wooden creates and anchored with tie-rods on
the loading surface of the articulated vehicle.
Carefully follow the instructions printed on the outside of the packaging to lift the crates.
Packaging can be recovered for possible re-use; therefore, it is good practice to try to keep
them in a protected place in order to avoid damaging them and making them unreliable. If
they have to be thrown out, it will be the responsibility of the Customer to dispose of them
according to the regulations in force in their own country.
MEDIUM AND SHORT DISTANCE TRANSPORT, where each individual component of the
machinery is fixed to a platform and covered with protective sheets.
The anchorage points for lifting are indicated on the transport packages.
All the indications for identification of the contents and for safe handling are also provided
on the outside of the various packages:
Address of recipient and sender.
Dimensions (length, width, height).
Gross, net and tare weight.
Centre of gravity.
Annotations and pictograms (i.e. fragile, tall, etc.).
Packing list plate (a copy must be present inside each package).
To Next Page
Loading...
Need help?
General