CRIMP DATA ANALYZER
CDA10
REV.01
8.4 MACHINE STOP PROCEDURE
Before carrying out the maintenance procedures described in the following chapter, the operator
must stop and put the machine in maintenance status, following the procedure below:
• Set the machine in optimal conditions to be able to resume operation without delays due to
abnormal cycle conditions.
• Isolate and padlock the power sources of the machine, if maintenance operations require it. In
other cases, make no changes.
• Check for the presence of residual energy and discharge it before operating on the device, if
necessary.
• Affix the sign "MACHINE IN MAINTENANCE - DO NOT OPERATION - WORKS IN PROGRESS, DO
NOT RUN" near the main switches;
• At the end of the maintenance operations, restore the previously deactivated power supplies.
• Before resuming normal operations on the machine, re-check the entire system in accordance
with the start-up procedures indicated in this manual.
To Next Page
Loading...