CRIMP DATA ANALYZER
CDA10
REV.01
4.3 LIFTING AND HANDLING
You must know the weight of the machine before performing any handling and/or lifting..
All handling and/or lifting operations must be carried out by qualified
personnel, aware of the standards regarding the lifting and handling of loads,
and in full compliance with them
.
Use a suitable lifting device, adequate
for the weight and the encumbrance of
the load to be handled
.
Always ensure correct balancing of the load. If it is unbalanced, immediately
place it on the ground and reposition it.
When the load is lifted to a height greater than 50 cm, the operators must
remain at a safe distance from the perimeter, greater than 2m
.
A break in the slings or an uncontrolled movement of the load are in fact
serious dangers to personnel safety.
To Next Page
Loading...
Need help?
General