CRIMP DATA ANALYZER
CDA10
REV.01
• The machine is built with different recyclable or non-recyclable materials. For this reason, its
removal involves careful separation of the materials: glass, steel, aluminium, copper, bronze,
special alloy, plastic, etc.
• The Manufacturer shall not be liable for damage caused by the use of any individual components
differing from those prescribed.
7.1 DISPOSAL
Throughout the entire period of use of the machine, no waste materials are produced/used.
However, the press machine produced/used waste material, for example lubricants. Some specific
regulations for environmental protection apply for the disposal of some of these materials.
See the machine manual for more information.
It is the Customer's obligation to be aware of the laws in force in his/her country and to operate in
such a way as to follow these laws.
If difficulty arises in disassembly, demolition and dismantling of the machine
or for greater safety, contact the Manufacturer and indicate the cause of the
removal and the serial number of the equipment
.
Scrapping must be carried out in compliance with the laws in force. These
rules must be r
espected.
To Next Page
Loading...
Need help?
General