FOCKE MELER GLUING SOLUTIONS TABLE OF CONTENTS
Check that the machine is working in the correct operating mode 6-7
All of the previous premises are OK but the unit still does not perform any pumping operations 6-7
Level sensor 6-8
The unit does not indicate the absence of adhesive 6-8
Dry air system 6-8
No dry air is fed to the tank 6-8
Hose 6-9
Hose does not heat 6-9
Hose does not stop heating 6-9
Temperature fluctuations in hose 6-9
Applicator 6-10
Applicator does not heat 6-10
Applicator does not stop heating 6-10
Temperature fluctuations in applicator 6-10
LAY OUT POWER BOARD 6-12
LAY OUT CONTROL BOARD 6-13
LAY OUT PUMP CONTROL BOARD 6-13
LAY OUT SENSOR BOARD 6-13
7. TECHNICAL CHARACTERISTICS 7-1
Generals 7-1
Dimensions 7-3
Micron gear range option accessories 7-5
Automatic feeder system 7-5
Air drying system for reactives adhesives 7-5
Pneumatic by-pass valve pressure control system 7-5
Level control system 7-5
Warning light option 7-5
Optional equipment 7-6
Wheel system 7-6
To Next Page
Loading...
