TABLE OF CONTENTS MA-5079-ENG MICRON GEAR ADHESIVE MELTER
Pump maintenance 5-7
Inspecting for leaks 5-7
Gear motor maintenance 5-7
Cleaning the motor fan 5-7
Checking the lubricant 5-7
Recommended lubricants 5-8
Safety Thermostat 5-8
Air dryer filter maintenance 5-8
Remove the equipment from its base 5-9
6. TROUBLESHOOTING 6-1
Melter 6-2
The unit does not turn on (5, 10 and 20 adhesive melters) 6-2
The unit does not turn on (35 adhesive melter) 6-2
Equipment shortcircuit malfunction 6-3
Tank 6-3
The tank does not heat (5, 10 and 20 adhesive melters) 6-3
The tank does not heat (35 adhesive melter) 6-3
The tank does not stop heating (5, 10 and 20 adhesive melters) 6-4
The tank does not stop heating (35 adhesive melter) 6-4
Temperature fluctuations in the tank 6-4
Manifold 6-5
The manifold does not heat (Micron, 1 geared motor) 6-5
The manifold does not heat (Micron, 2 geared motors) 6-5
The manifold does not stop heating (Micron, 1 geared motor) 6-5
The manifold does not stop heating (Micron, 2 geared motores) 6-6
Temperature fluctuations in the manifold/ manifolds 6-6
Melter does not pump 6-6
Problems associated with temperatures 6-6
The pump control board has been switched off 6-6
Pump control board alarms 6-7
To Next Page
Loading...
