TROUBLESHOOTING
SERVICE MANUAL NUMBER 22
90-860074--1 FEBRUARY 2002 Page 1C-19
Engine Noise
No definite rule or test will positively determine source of engine noise; therefore, use the
following information only as a general guide to engine noise diagnosis.
1. Use a timing light to determine if noise is timed with engine speed or one-half engine
speed. Noises timed with engine speed are related to crankshaft, rods, pistons, piston
pins, and flywheel. Noises timed to one-half engine speed are valve train related.
2. The use of a stethoscope can aid in locating a noise source; however, because noise
will travel to other metal parts not involved in the problem, caution must be exercised.
3. Try to isolate the noise to location in engine: front to back, top to bottom. This can help
determine which components are at fault.
4. Sometimes noises can be caused by moving parts coming in contact with other
components. Examples are: flywheel or coupler; exhaust flappers rattling against
exhaust pipe; crankshaft striking (pan, pan baffle, or dipstick tube); rocker arm striking
valve cover; and loose flywheel cover. In many cases if this is found to be the problem,
a complete engine teardown is not necessary.
5. When noise is isolated to a certain area and component, removal and inspection will be
required. Refer to proper SECTIONs of service manual for information required for
service.
6. If noise cannot be distinguished between engine and drive unit, remove drive from boat.
Run a water supply directly to engine. Run engine without the drive to determine if noise
is still there.
To Next Page
Loading...
Need help?
General