STARTING SYSTEM
SERVICE MANUAL NUMBER 22
90-860074--1 FEBRUARY 2002 Page 4A-3
Identification
70809
a
a-Identification Number Location On Starter
Specifications
IMPORTANT: The starter motor is designed to operate under great overload and
produce a high horsepower for its size. It can do this only for a short time, since
considerable heat accumulates and can cause serious damage. For this reason, the
cranking motor must never be used for more than 15 seconds at any one time.
Cranking should not be repeated without a pause of at least 2 minutes to permit the
heat to escape.
Description
Specification
I.D. Number 0 001 362 3--
Engine Rotation Left Hand (Counterclockwise)
Minimum Required Cranking
Battery Size (4 and 6 cylinder)
750 cca, 950 mca or 180 Ah
No-Load Test 11.5 Volts, 125 Amps At 7000 rpm
Torque Specifications
Description Nm lb-in. lb-ft
Starter Motor 68 50
Solenoid Tighten Securely
Lubricants / Sealants / Adhesives
Description Part Number
Liquid Neoprene 92-25111--3
2-4-C Marine Lubricant With Teflon 92-802861Q1
To Next Page
Loading...
Need help?
General