SERVICE MANUAL NUMBER 22
STERNDRIVE (MCM) MODELS
Page 2A-30 90-860074--1 FEBRUARY 2002
Battery Cables
1. Connect battery cables to engine:
a. Make sure that grounding stud and starter solenoid terminal are free of paint and any
other material that could cause a poor electrical connection.
b. After battery cables are connected, apply a thin coat of Liquid Neoprene to the
terminals.
c. Be sure to slide rubber boot over the positive (+) terminal after Liquid Neoprene
dries.
2. Connect battery cables to battery by FIRST connecting positive (+) battery cable
(usually red) to positive (+) battery terminal. Tighten clamp securely. Then, connect
negative (–) battery cable (usually black) to negative (–) battery terminal. Tighten clamp
securely.
NOTE: Spray terminals with a battery connection sealant to help retard corrosion.
To Next Page
Loading...
