INBOARD (MIE) MODELS SERVICE MANUAL NUMBER 22
Page 2B-8 90-860074--1 FEBRUARY 2002
d. Ensure rear engine mount rubber bushings are positioned so that slots in bushing
are positioned horizontally. If necessary, loosen center bolt and turn bushing. Torque
to 41-61 Nm (30-45 lb-ft).
50688
a
b
c
a-Rubber Bushing
b-Slots
c-Bolt
3. Attach a suitable sling to lifting eyes on engine and adjust so that engine is level when
suspended. Refer to Removal for location of engine lifting eyes.
CAUTION
Do NOT allow lifting sling to hook or compress engine components or damage will
occur.
To Next Page
Loading...
Need help?
General